Why a Kenmore ice maker is diagnosed by symptom
Kenmore freestanding ice makers, almost entirely Whirlpool-built (106-series), have no fault-code display; they show simple indicator lights at most, and the automatic icemaker built into a refrigerator is a component with no display of its own. Either way, the ice maker is read by what it does — no ice, slow ice, small or hollow cubes, bad-tasting ice, or leaks — so the symptom is the diagnostic.
No-ice and slow-ice symptoms
No ice at all usually traces to a closed or kinked water supply, low household pressure, a failed inlet valve, or a failed harvest module. Small or hollow cubes point at low water pressure or a kinked line. Bad-tasting or dirty ice traces to old water sitting in the line or mineral buildup in the bin — flush the line and clean the bin. Cubes that fuse together in the bin point at a low ambient temperature or a stuck harvest cycle.
Leak and what-to-do symptoms
Water on the floor or in the bin usually traces to a loose supply-line connection, a dripping inlet valve, or a clogged drain. Confirm the supply shutoff is fully open, clean the bin, and check for kinks in the line before suspecting a part. If the ice maker still will not produce, runs slow, tastes off, or leaks, an experienced, independent technician should diagnose the inlet valve, harvest module, or drain with the correct genuine OEM part matched to your unit’s actual builder — an in-refrigerator module is handled as part of refrigerator repair. Browse the symptom guides on the ice maker diagnostics page, then book ice maker repair.