What F1E2 means on your Kenmore dishwasher (kenmore f1e2 error)
A kenmore f1e2 error is reported as corrupted or incompatible memory on the electronic control board of Whirlpool-built Kenmore dishwashers (106/110/198/664/665/850-prefix). Like F1E1, this specific code was not confirmed on a single Whirlpool primary page in our research and is presented as a typical/pattern code from general Whirlpool-platform references.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore dishwasher. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The dishwasher will not complete a cycle
- Settings are lost or reset unexpectedly
- The display shows F1E2 at power-up or mid-cycle
- The control panel becomes unresponsive
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Corrupted or incompatible control-board memory — the board’s stored program data is invalid
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Power the dishwasher off at the breaker for a few minutes to force a full reset.
- Restart and attempt a normal cycle.
- Avoid repeatedly cycling power in quick succession.
- If F1E2 returns, book service rather than continuing to reset it.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the electronic control board and firmware/memory. The correct part for your Kenmore dishwasher is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
F1E2 is a control-board-level problem on this Whirlpool-built Kenmore platform — book an experienced technician to reflash or replace the board rather than troubleshooting further at home. Because this condition is rated High severity, it is safest to stop using the dishwasher and arrange service promptly rather than keep retrying, and to shut off power or water at the source if anything looks, smells, or sounds unsafe. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore dishwasher model and serial number ready so the right part for your exact build can be matched before the visit and the F1E2 condition resolved in as few trips as possible.
Related help and Kenmore resources
If the F1E2 condition keeps returning after these checks, book Kenmore dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related F1E1 control-relay failure. For full manufacturer specifications and model lookup, visit kenmore.com.
