What F2 means on your Kenmore range (kenmore frigidaire f2 error)
A kenmore frigidaire f2 error is a verified code, confirmed by Frigidaire/Electrolux repair references (the same AskGene source already used for this site’s F10/F11/F30/F31 codes), meaning an extreme oven temperature reading on your Frigidaire/Electrolux-built Kenmore range or oven — a model whose first three digits are 119, 253, 336, 417, 587, 622, 628, 719, 790, 791, or 970. The documented check is whether the RTD sensor resistance reads above roughly 1,100 ohms, which calls for sensor replacement. This is a safety-relevant overheating condition distinct from F30/F31 (an open/shorted sensor circuit rather than an extreme reading).
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore range. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The display shows F2 and the oven shuts itself off
- The oven runs noticeably hotter than the set temperature before shutting down
- A burning smell may accompany the shutdown
- The code recurs when the oven is restarted
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- RTD oven sensor reading extreme resistance (above ~1,100 ohms) — the sensor itself has failed
- EOC board failure — less commonly, the control board itself
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Turn off the range at the breaker and do not attempt to bake or broil until it is inspected.
- Do not attempt to test the RTD sensor resistance yourself unless qualified to safely do so.
- Book service for technician-level diagnosis of an overheating-related problem.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the rtd oven sensor and electronic oven control (eoc) board. The correct part for your Kenmore range is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
F2 is a safety-relevant problem on this Frigidaire/Electrolux-built Kenmore platform that needs an experienced technician to test the RTD sensor resistance and replace it (or the EOC board) before the oven is used again. Because this condition is rated Critical severity, it is safest to stop using the range and arrange service promptly rather than keep retrying, and to shut off power or water at the source if anything looks, smells, or sounds unsafe. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore range model and serial number ready so the right part for your exact build can be matched before the visit and the F2 condition resolved in as few trips as possible.
Related help and Kenmore resources
If the F2 condition keeps returning after these checks, book Kenmore range repair, browse our range error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related F10 runaway temperature. For full manufacturer specifications and model lookup, visit kenmore.com.
