What FE means on your Kenmore washer (kenmore fe error)
A kenmore fe error is widely reported as an overfill or water-level (fill) error on LG-built Kenmore washers (795/796-prefix). This specific code was not pulled from a single LG primary support page in our research and is presented as a typical/pattern code, consistent across repair references, rather than an independently verified LG listing.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The water level appears higher than expected
- The display shows FE
- The drain pump may run to bring the level down
- The cycle pauses during fill
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Water inlet valve stuck open — continuing to fill past the correct level
- Pressure sensor failure — the sensor is misreading the water level
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Cancel the cycle and turn off the water supply if water keeps entering.
- Power-cycle the washer at the breaker and restart a normal cycle.
- Avoid repeated resets if FE returns immediately.
- Book service if the condition continues.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the water inlet valve and pressure sensor. The correct part for your Kenmore washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
FE needs an experienced technician to test the water inlet valve and pressure sensor on this LG-built Kenmore washer. This condition is rated Medium severity, so there is no emergency — but if the same FE keeps returning after the checks above, a technician should confirm the cause before any part is replaced. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore washer model and serial number ready so the right part for your exact build can be matched before the visit and the FE condition resolved in as few trips as possible.
Related help and Kenmore resources
If the FE condition keeps returning after these checks, book Kenmore washer repair, browse our washer error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related PE pressure-sensor failure. For full manufacturer specifications and model lookup, visit kenmore.com.
