What F8E2 means on your Kenmore dishwasher (kenmore f8e2 error)
A kenmore f8e2 error is reported as a drain pump electrical problem on Whirlpool-built Kenmore dishwashers (106/110/198/664/665/850-prefix). Like F8E1 on this platform, it was not confirmed on a Whirlpool primary page in our research and is presented as a typical/pattern code from general Whirlpool-platform references — distinct from the mechanical slow-drain condition, this points at the pump’s electrical circuit itself.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore dishwasher. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The dishwasher will not drain at all
- No pump sound is heard during the drain step
- The cycle aborts partway through
- The code recurs on every attempted cycle
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Drain pump motor or wiring failure — the pump is not receiving or responding to power correctly
- Control-board driver failure — the board can no longer energize the pump
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Power the dishwasher off at the breaker for a few minutes to force a reset.
- Confirm the drain hose and filter are clear (rule out the mechanical F8E1 condition first).
- Restart a normal cycle and listen for the pump attempting to run.
- If F8E2 returns, book service rather than continuing to reset it.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the drain pump, pump motor wiring, and control board. The correct part for your Kenmore dishwasher is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
F8E2 needs an experienced technician to test the drain pump motor, wiring, and control board on this Whirlpool-built Kenmore dishwasher. Because this condition is rated High severity, it is safest to stop using the dishwasher and arrange service promptly rather than keep retrying, and to shut off power or water at the source if anything looks, smells, or sounds unsafe. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore dishwasher model and serial number ready so the right part for your exact build can be matched before the visit and the F8E2 condition resolved in as few trips as possible.
Related help and Kenmore resources
If the F8E2 condition keeps returning after these checks, book Kenmore dishwasher repair, browse our dishwasher error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related F8E1 slow-drain problem. For full manufacturer specifications and model lookup, visit kenmore.com.
