What Not Spinning means on your Kenmore washer (kenmore washer not spinning)
A kenmore washer not spinning problem means the washer fills, agitates, and drains, but the spin step never engages or spins weakly. Remember that Kenmore washers were built by different OEMs depending on the model prefix — a 110/665-prefix Whirlpool-built unit and a 795/796-prefix LG-built unit may show a specific code for this (dU on Whirlpool, UE or dE on LG), so check your model’s first three digits if a code is displayed.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The washer completes wash and drain but the spin never starts
- Clothes come out soaking wet at the end of the cycle
- A clicking or humming sound occurs where spin should begin
- The lid or door does not seem to lock during spin
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Lid or door switch not engaging — the washer will not spin if it cannot confirm the lid/door is closed and locked
- Unbalanced load — the washer is refusing to spin to protect itself from an uneven load
- Worn or broken drive belt — the belt driving the tub for spin has failed
- Faulty lid-lock assembly — the locking mechanism is not confirming a locked state
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Redistribute the load evenly in the drum and restart the spin step.
- Confirm the lid or door closes and latches fully.
- Check that nothing is preventing the lid switch from engaging.
- If spin still will not engage with a balanced, properly closed load, further diagnosis is needed.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the lid/door switch, drive belt, lid-lock assembly, and load balance. The correct part for your Kenmore washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
A washer that will not spin after confirming load balance and the lid/door switch needs an experienced technician to test the drive belt and lid-lock assembly for your Kenmore’s specific OEM platform. This condition is rated Medium severity, so there is no emergency — but if the same Not Spinning keeps returning after the checks above, a technician should confirm the cause before any part is replaced. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore washer model and serial number ready so the right part for your exact build can be matched before the visit and the Not Spinning condition resolved in as few trips as possible.
Related help and Kenmore resources
If the Not Spinning condition keeps returning after these checks, book Kenmore washer repair, browse our washer error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related not draining symptom. For full manufacturer specifications and model lookup, visit kenmore.com.
