What Light Not Working means on your Kenmore range hood (kenmore range hood light not working)
A kenmore range hood light not working symptom means the fan may still run normally, but the cooktop light stays dark. On older hoods this is usually a simple bulb; on newer LED-equipped hoods the light is often a sealed module rather than a screw-in bulb, and a failed switch can also be the cause either way.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore range hood. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The light does not turn on when the switch is pressed
- The light flickers before going dark entirely
- The fan works normally while only the light has failed
- The light worked intermittently before failing completely
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Burned-out bulb — on hoods with a replaceable incandescent or halogen bulb
- Failed LED module — on newer hoods the light is a sealed assembly rather than a replaceable bulb
- Faulty light switch — the switch itself has failed independently of the fan circuit
- Loose or damaged wiring connection — a connection to the light assembly has come loose
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Check for a burned-out bulb on models with a replaceable bulb, and replace with the correct type and wattage.
- Confirm the fan still works normally, which narrows the problem to the light circuit specifically.
- Test the light switch for a solid click and response.
- If a bulb replacement does not restore the light, further diagnosis is needed.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the light bulb/led module, light switch, and wiring harness. The correct part for your Kenmore range hood is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
If the light still will not work after a bulb check, an experienced technician should test the switch and wiring on this Kenmore range hood. This condition is rated Low severity, so there is no emergency — but if the same Light Not Working keeps returning after the checks above, a technician should confirm the cause before any part is replaced. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore range hood model and serial number ready so the right part for your exact build can be matched before the visit and the Light Not Working condition resolved in as few trips as possible.
Related help and Kenmore resources
If the Light Not Working condition keeps returning after these checks, book Kenmore range hood repair, browse our range hood error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. For full manufacturer specifications and model lookup, visit kenmore.com.
