What EHE/ELE means on your Kenmore dryer (kenmore ehe ele error)
A kenmore ehe ele error is a verified LG code, confirmed on LG’s own USA support pages, meaning high temperature or humidity was detected in the drum on your LG-built Kenmore dryer (795/796-prefix). This is often tied to how the dryer is leveled or drained, per LG’s own guidance, alongside vent restriction.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different problem on your Kenmore dryer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a wash or cook cycle, a spill, or recent installation or service.
- The display shows EHE or ELE
- The dryer runs unusually hot to the touch
- Clothes take longer to dry or come out still damp
- The code appears mid-cycle rather than at start
Common causes
Several different problems can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Kenmore parts.
- Vent restriction — the exhaust duct is partially blocked, causing heat to build up
- Dryer not level — improper leveling can affect internal drainage/humidity sensing on some models
- Drainage issue on condensing/ventless models — condensate is not draining as designed
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Check and clean the exhaust vent duct for restriction, as with d90/d95.
- Confirm the dryer is level on all four feet.
- On a condensing/ventless model, check the condensate drain path or reservoir per the owner’s manual.
- Run a cycle and confirm EHE/ELE clears.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the exhaust vent, heating element, leveling feet, and drain path (condensing models). The correct part for your Kenmore dryer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so performance, safety, and the appliance long working life are all protected. Confirming the failed part before ordering avoids replacing more than the problem actually requires.
When to call a technician
EHE/ELE that persists after clearing vent restriction and confirming leveling needs an experienced technician to test the heating element and drainage system on this LG-built Kenmore dryer. This condition is rated Medium severity, so there is no emergency — but if the same EHE/ELE keeps returning after the checks above, a technician should confirm the cause before any part is replaced. As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. When you book, have your Kenmore dryer model and serial number ready so the right part for your exact build can be matched before the visit and the EHE/ELE condition resolved in as few trips as possible.
Related help and Kenmore resources
If the EHE/ELE condition keeps returning after these checks, book Kenmore dryer repair, browse our dryer error-code guides and step-by-step repair guides, or schedule service in your area on our locations page. See also the related d90/d95 vent blockage. For full manufacturer specifications and model lookup, visit kenmore.com.
